Screen Wiring and Configuration

Screen Wiring

TFT Resistive Screen Wiring

TFT Resistive Screen Wiring

tip

• The TFT screen package includes two FPC cables, one is 14P (narrow) and the other is 16P (wide)
• Please use the 14P (narrow) for resistive screens!!!

1. FLY-Pi V2 TFT resistive screen wiring

TFT V2 with G2T Screen Wiring

TFT Resistive Screen Wiring

tip

• The TFT screen package includes two FPC cables, one is 14P (narrow) and the other is 16P (wide)
• For G2T screens with TFT V2, please use the 16P (wide)!!!

1. Install G2T and TFT screen

Using resistive screen

Using capacitive screen

HDMI Wiring

HDMI Wiring

1. FLY-HDMI-LCD5 screen wiring

Wiring method 1

Wiring method 2

---

Screen Configuration

FLYOS-FAST System - Screen Configuration

FLYOS-FAST System - Screen Configuration

1. Open the device IP address in the browser, for example: http://192.168.6.110/

   fluidd: As shown below: Uncheck -> Filter hidden files and folders.

   mainsail: As shown below: Check -> Show hidden files.

2. You can now see the .flyos-config folder. Enter this folder to find the sys-config.conf file.

3. Open the sys-config.conf file, modify the required configuration items, then save -> close.

warning

• HDMI screen should be configured as: hdmi, note that there must be no space after =!!!
• Resistive screen should be configured as: fly-tft-v1, note that there must be no space after =!!!, ensure the screen DIP switch is set to Resi
• Capacitive screen should be configured as: fly-tft-v2-c, note that there must be no space after =!!!, ensure the screen DIP switch is set to Cap
• klipper_screen should be configured as: 1, note that there must be no space after =!!!
• Note: The format of the configuration items in the sys-config.conf file is key=value. Do not modify this format!!! Otherwise the configuration will not take effect!!!

4. After saving the modifications, restart the system to apply the changes.

FLYOS-Armbian System - Screen Configuration

FLYOS-Armbian System - Screen Configuration

info

• Connect the host computer to WiFi and obtain the host IP. Then enter IP+:9999 in the browser to access FLY TOOLS for screen configuration.
• For example, if the host IP is 192.168.6.110, enter 192.168.6.110:9999 in the browser.

1. Open FLY TOOLS. As shown in the figure below, enable Klipper Screen, select the screen model, click the pink button at the bottom right Save Configuration, and restart the host computer to apply the changes!

warning

• Resistive screen select: fly-tft-v1, ensure the screen DIP switch is set to Resi
• Capacitive screen select: fly-tft-v2-c, ensure the screen DIP switch is set to Cap

Resistive screen:	Capacitive screen, requires G2T:
HDMI screen:

2. After saving the configuration, restart the host computer to apply the changes!

---