Introduction
The FLY-SHT36-PRO is a toolboard designed by Guangzhou Melyun Electronic Technology Co., Ltd. for the print head of 3D printers. Using this toolboard, four wires can replace the complex wiring between the original motherboard and the print head, optimizing the layout. The FLY-SHT36-PRO is suitable for 36 stepper motors and integrates a CAN transceiver, USB port, TMC5160 driver, ADXL345 acceleration sensor, two controllable fans, and other functional toolboard features.
SHT36 PRO Firmware Compilation and Flashing
3 items
Tool Board ID Read & View
* Before searching for the ID, connect the tool board to a UTOC or a mainboard flashed with bridge firmware using an XT30 data cable. Refer to the wiring diagram below.
Wiring Reference
The included blue heatsink should be attached to the driver!!!
配置参考
Accelerometer Usage
Usage Tutorial
D Models and Schematics
* This document provides the following resources
SPI Not Working Solutions
Specific Cause