FLY-Pi V3 Usage Precautions
Always disconnect the power before performing any wiring operations! When flashing firmware, please also operate according to the guide requirements.
1. Power Requirements
- Power via Type-C (Recommended for first boot): Use a power adapter of 5V/2A or higher. Some computer USB ports may not provide sufficient power, which could cause the system's first automatic expansion to fail.
- Power via DC power terminal: Supports DC 12V-24V input, suitable for daily work scenarios.
- For detailed power supply instructions, please refer to Host Power Supply.
2. Storage Configuration
FLY-Pi V3 does not come with any storage device pre-installed. You must configure at least one of the following storage media:
- Option 1 (Recommended): Purchase the FLY customized M2WE module.
- Option 2: Prepare your own Micro SD (TF) card, with a capacity between 16GB and 128GB.
3. Important Warnings
It is strictly forbidden to use the TFT screen and the SPI accelerometer interface simultaneously!
The TFT screen interface (FPC-TFT), the SPI accelerometer interface (ZH1.5-7P), and the RRF expansion interface share the same set of SPI resources on the hardware. Connecting them simultaneously will cause device malfunction.
The onboard M2WE expansion interface uses a FLY proprietary protocol. It is absolutely forbidden to connect any standard or unofficial M.2 devices, as this will cause permanent hardware damage to the mainboard.