Screen wiring and configuration
Screen wiring
- TFT resistive screen wiring
- HDMI wiring
Screen configuration
- FLYOS-FAST system - screen configuration
- FLYOS-Armbian system - screen configuration
FLYOS-FAST system - screen configuration
-
Open the device IP address in the browser, for example:
http://192.168.6.110/fluiddas shown in the figure:uncheck->filter hidden files and folders.
mainsailas shown in the figure:check->show hidden files.
-
At this point, you can see the
.flyos-configfolder, entering this folder will have thesys-config.conffile.
- Open the
sys-config.conffile, modify the configuration items that need to be modified,save->closeto complete.
warning
- Configure
HDMI screenas:hdmi, please note that there must be no space after = !!! - Configure
resistive screenas:fly-tft-v1, please note that there must be no space after = !!!, confirm that the dip switch on the back of the screen is set toResi - Configure
klipper_screenas:1, please note that there must be no space after = !!! - Note: The format of configuration items in the
sys-config.conffile iskey=value, do not modify the format私自!!! Otherwise, the configuration will not take effect!!!
- After modifying and saving,
reboot the systemto take effect.
FLYOS-Armbian system - screen configuration
info
- Connect the host computer to WiFi, and after obtaining the host computer's IP, enter
IP+:9999in the browser to access FLY TOOLS and perform screen-related configurations - For example, if your host computer's IP address is
192.168.6.110, you need to enter192.168.6.110:9999in the browser
- Open FLY TOOLS, follow the steps shown in the figure below,
enable Klipper Screen,select the screen model, click the pink button at the bottom rightsave configuration, then restart the host computer to take effect!
warning
- Select
resistive screen:fly-tft-v1, confirm that the dip switch on the back of the screen is set toResi
 |
 |
- After saving the configuration, restart the host computer to take effect.
Loading...