Skip to main content

TMC 5160 Pro V1.5

Basic Parameters​

  • Input voltage: 24-48V
  • Maximum current: 6A
  • Suitable for: Marlin/Klipper/RRF firmware
  • Drive mode support: TMC: SPI
  • Stepper/direction interface with microstepping interpolation microPlyer
  • Highest resolution of 256 microsteps
  • Supports stealthChop2 silent operation and smooth motion
  • Supports resonance suppression for mid-frequency resonance
  • Supports spreadCycle high-dynamic motor control chopper
  • Supports dcStep load-related speed control
  • Supports stallGuard2 high-precision sensorless motor load detection
  • Supports coolStep current control, up to 75% energy savings

Motherboard Jumper Instructions​

  • TMC5160 Pro uses SPI jumper
  • The FLY-driven SPI pin is the fourth pin from the left downwards, and the CS pin is the SPI pin. If the motherboard does not correspond to the pin position, SPI cannot be used

Motherboard FPC Installation​

12V FAN Wiring​

TMC5160 Pro Reference Configuration​

dangerous
  • The drive sampling resistor is sense_resistor: 0.033 please do not set incorrectly
  • spi_bus and spi_software can only choose one

SPI Mode Reference Configuration​

[tmc5160 stepper_x]
cs_pin:
spi_bus:
# spi_software_mosi_pin:
# spi_software_miso_pin:
# spi_software_sclk_pin: 
run_current: 1.0                    # Motor running current value
interpolate: False                  # Whether to enable 256 microstep interpolation (True for enabled, False for disabled)
sense_resistor: 0.033
stealthchop_threshold: 0
driver_DISS2G: 1
driver_DISS2VS: 1

Infinite Position Usage Instructions​

Infinite Position Usage Tips
  • Infinite position usage requires occupying a limit port; normally, the first drive position uses IO1, the second drive position uses IO2, and so on.
  • When using infinite positions, please ensure not to connect anything to the corresponding limit port.
  • For some FLY mainboards that are directly connected to the drive port, please check if DIAG is directly connected to the corresponding pin.
Infinite Position Usage Tips
  • This driver needs to have the 4-pin FPC installed to be used
  • The original endstop_pin: needs to be shielded or deleted, and add endstop_pin: tmc5160_stepper_x:virtual_endstop
  • After configuring diag0_pin:, the limit status is not triggered
  • Configuring driver_SGT: requires testing an appropriate value by yourself
  • Reference Configuration
[stepper_x]
# endstop_pin:PF3
endstop_pin: tmc5160_stepper_x:virtual_endstop
homing_retract_dist: 0        # Retraction distance not changed to 0 may cause homing failure

[tmc5160 stepper_x]
diag0_pin: ^!
driver_SGT: 1

#   After configuration, please ensure the limit status is not triggered
#   This pin usually uses "^" prefix to enable internal pull-up
#   Sensitivity is related to belt tightness and needs to be adjusted by yourself
#  (Ensure that driver_SGTHRS is also set to an appropriate sensitivity)