Tip

• The Super5 Pro uses a TF card for firmware flashing by default.
• Please prepare a TF card with a capacity not exceeding 32G.
• Off-brand memory cards may cause flashing failures. Please try to use the recommended memory cards below to update the firmware.
• The transfer speed of the TF card should ideally be class10 class or class10 class or higher. It is recommended to use TF cards from brands such as SanDisk.

Firmware Flashing Instructions

Tip

• The Super5 Pro comes with the TF card bootloader pre-flashed from the factory, so there is no need to flash it again yourself.

Choose Firmware Type

Please confirm the connection method first.

• If not using a CAN toolboard: choose USB firmware.
• When a CAN toolboard is required: choose USB Bridge CAN Firmware.
• Only one of the two firmware types can be selected; do not flash both. The Super5 Pro firmware is flashed via TF card.

Firmware Type	Applicable Scenario	Advantages	Confirm Before Choosing	Operation
USB Firmware	When not using a CAN toolboard	Stable communication, simple configuration	If not using a CAN toolboard, use the USB firmware	Compile USB Firmware
USB Bridge to CAN Firmware	When a CAN toolboard is required	Can connect multiple CAN devices, reduces USB usage	Choose only when a CAN toolboard is needed; confirm CAN wiring, terminal resistors, and CAN baud rate settings are consistent	Compile USB Bridge to CAN Firmware