Firmware Flashing Instructions

Notes

• The PRO X10 comes pre-flashed with Katapult
• Once BL has been flashed, there is no need to flash BL again
• The PRO X10 has two types of BL: Katapult firmware and TF card-flashed BL firmware
• If needed, you can reflash the BL firmware of your choice

Important

• The mainboard firmware must be flashed via Katapult to install Klipper
• If you are certain that the mainboard has already been flashed with Katapult, skip the final step of flashing the Katapult firmware
• You can quickly press the reset button twice and check if an LED on the mainboard starts blinking; if so, the mainboard has entered the Katapult firmware mode

How to Determine Which Firmware You Need

Tip

• Please note that you only need to flash one of the firmware types

• The Pro X10 can be connected to the host machine using the following methods:
• USB Firmware
  • Advantages: Reliable and stable communication
  • Disadvantages: Multiple USB devices may affect data transmission
• USB Bridged Firmware
  • Advantages: Can connect multiple devices without occupying a USB port
  • Disadvantages: When used with KlipperScreen, it may cause errors such as homing timeout

DIP Switch Instructions

Please check the DIP switch status

Loading...

TF Card Slot Usage Instructions

Loading...