Introduction

FLY PRO_X10

Utilizes a 32-bit 550 MHz ARM Cortex-M7 series STM32H723ZGT6 main control chip
The mainboard and core board are connected via BTB, compatible with core boards such as Orange Pi CM4 and Raspberry Pi CM4
The mainboard is equipped with a BOOT button, allowing users to update the mainboard bootloader via DFU
Ten pluggable TP drivers, enabling driver mode switching without any jumpers
Onboard DIAG function pins, allowing use of infinite homing simply by plugging or unplugging jumper caps
Driver power supports HVIN and VIN power selection
MCU firmware can be updated via MicroSD card or through Klipper's make flash command via DFU
Six two-wire controllable fans with pluggable MOS support, two four-wire fans, and one VCC fan
Digital fan voltage selectable between 24V, 12V, and 5V, eliminating the need for external voltage conversion modules and reducing the risk of mainboard damage
Features replaceable fuse design.

MCU: STM32H723ZGT6
Driver Power: VIN (12V-24V), HVIN (12V-48V)
Mainboard Power: VIN (12V-24V)
Heated Bed Power: BED IN (12V-24V)
Heating Ports: Heated Bed (BED OUT), Heating Elements (HETA0, HETA1, HETA2, HETA3)
Driver Work Modes Supported: SPI, UART, STEP/DIR
Expansion Interfaces: BLTouch (Servos, Probe), UART X1, High-Voltage Limit Switch Port X1

Output Port	Maximum Current at 24V Power Supply	Maximum Current at 12V Power Supply
Heated Bed Port	15A	7.5A
Heating Port	6A	3A
Fan Port	1A	0.5A