Product Introduction
- The main control adopts ESP32-S3R8, with stronger performance than ESP32. It features 8MB PSRAM and 16MB Flash. The screen is an IPS display with high resolution, high brightness, wide viewing angle, and fine colors. It supports capacitive touch.
Product Features
- Currently, there are 6 pages, which can be switched by swiping left, right, up, or down.
-
Home page (displays statuses such as standby, printing, stopped, and errors)
-
Extrusion (controls extrusion, retraction, and extrusion temperature)
-
System Services (controls the start, stop, and restart of services such as Host, Klipper, and Moonraker)
-
Settings (used to configure various parameters of Halo, including Wi-Fi, IP, language, and backlight brightness)
-
Device Information (displays Halo information, firmware version, checks for updates, etc.)
-
Filament Detection: detects broken or clogged filament, measures filament length, and can automatically pause and activate GPIO47 after a specified length of clogging (all features are disabled by default and can be enabled in settings)
-
Power Off After Printing: supports shutting down the host and activating GPIO48 after a set delay following print completion (all features are disabled by default and can be enabled in settings)