Product Introduction
- The main controller uses ESP32-S3R8, which offers better performance than ESP32. It features 8MB PSRAM and 16MB Flash. The screen is an IPS display with high resolution, high brightness, wide viewing angles, and fine color reproduction. Capacitive touch is supported.
Product Features
- Currently, there are a total of 6 pages, switchable by swiping left, right, up, or down.
-
Home page (displays statuses such as standby, printing, stopped, error, etc.)
-
Extrusion (controls extrusion, retraction, extrusion temperature)
-
System services (controls the start, stop, and restart of services such as the host, Klipper, Moonraker, etc.)
-
Settings (used to configure various parameters of HALO, including Wi-Fi, IP, language, backlight brightness, etc.)
-
Device information (displays HALO information, firmware version, checks for updates, etc.)
-
Filament detection: supports filament breakage and clogging detection, filament length detection, and automatic pause with GPIO47 pulled high after reaching a specified clogging length (all disabled by default, can be enabled in settings)
-
Shutdown after printing: supports shutting down the host and pulling GPIO48 high after a set delay upon print completion (all disabled by default, can be enabled in settings)