USB Firmware Compilation

Start Compiling

• A host computer with the klipper service installed is required Connect via SSH over the network
• And the device is connected to the host computer
• Note: Please use a regular host computer, such as Raspberry Pi FLY. If it is a modified host computer (such as a WiFi stick, Redmi, etc.), due to too many issues, we cannot provide technical support

FlyOS-Armbian system and general system notes

warning

• Notes on FlyOS-Armbian system and general system
  • Ordinary host computer systems such as Raspberry Pi, FLY are viewed in this category
  • Do not use the ROOT user for any operations on these host computers
  • Please use a normal user for operations
  • To switch users, for FlyOS-Armbian system use the su fly command to switch to a normal user
  • For other systems, use the su <your host computer username> command to switch to a normal user

  su <your host computer username>

FlyOS-FAST system notes

warning

• Notes on FlyOS-FAST system
  • The default username for FAST system is root, password is mellow
  • Compiling firmware can only be done using the root user
  • And FAST system only has ROOT user, you don't need to switch users!!!

::: tip

• Please ensure that the host machine can connect to the network normally.
• Before compiling the firmware, use SSH to log in to the host machine via the network.
• Do not use a serial port tool to log in to the host machine.

:::

Klipper Firmware Compilation and Configuration Page Operation Instructions

::: tip

Please make sure that the keyboard input method is in half-width mode, i.e., English mode.

:::

1. The key ↑ (up arrow) and ↓ (down arrow) on the keyboard are used to move the cursor up and down to select menu items.
2. The confirm key Enter or spacebar Space is used to check the menu or enter a sub-menu.
3. The exit key ESC is used to return to the previous menu.
4. The Q key is used to exit the Klipper firmware configuration page.
5. When exiting the Klipper firmware configuration page and there is a prompt, press the Y key to save the configuration file.

::: warning

If there are fewer options in the configuration page, please first check [ ] Enable extra low-level configuration options to display some hidden options.

:::

Below is the introduction on how to compile the firmware:

• After connecting to SSH, enter the following command and press Enter:

  cd ~/klipper && rm -rf ~/klipper/.config && rm -rf ~/klipper/out && make menuconfig

• Where rm -rf ~/klipper/.config && rm -rf ~/klipper/out is to delete previous compilation data and firmware, make menuconfig is for compiling the firmware, after execution, the following interface should appear

  

• Select Enable extra low-level configuration options and press Enter

  

• Enter the menu Micro-controller Architecture then select STMicroelectronics STM32 and press Enter

  

• Enter the menu Processor model, select STM32F407 and press Enter

  

• Select Bootloader offset, select: 32KiB bootloader

  

• Communication interface, select: USB (on PA11/PA12)

  

• Press the Q key, and Save configuration appears, then press Y key
  
• Now the configuration should be saved and exited to the command line interface
• Enter the following command to start compiling, it takes some time

make -j4

• If the following content is output, the compilation is successful

  Linking out/klipper.elf
  Creating hex file out/klipper.bin

Firmware Flashing

tip

Execute the following command to flash the firmware

sudo fly-flash -d c8 -h -f ~/klipper/out/klipper.bin