Skip to main content

Halo Page Operation Introduction

Page Structure​

  Print Files Page         Home             Extrude Page        Sys Service         Setting          Dev Info
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
|             |    |             |    |             |    |             |    |             |    |             |
| Print Files |<-->|     Home    |<-->|   Extrude   |<-->| Sys Service |<-->|   Setting   |<-->|  Dev Info   |
|             |    |             |    |             |    |             |    |             |    |             |
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
                         ∧
                         |
                         ∨
                   +-------------+
                   |             |
                   | Blocking Det|
                   |             |
                   +-------------+
                   Clog Detection Page
            (This page appears only when clog detection is enabled in settings)

Home Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below
  1. Click: Enter the extrusion temperature setting, adjust the temperature by dragging the ring slider, click area 1 again to confirm the set temperature
  2. Click: Enter the hotbed temperature setting, adjust the temperature by dragging the ring slider, click area 2 again to confirm the set temperature

Extrude Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below
  1. Click: Increase extruder target temperature by 1
  2. Long press: Enter the extrusion temperature setting, adjust the temperature by dragging the ring slider, click again to confirm the set temperature
  3. Click: Decrease extruder target temperature by 1
  4. Click: Extrude
  5. Swipe up/down: Select the length for extrusion or retraction, unit in mm
  6. Click: Retract
  7. Long press: Enter the extrusion speed setting as shown in Figure 2 above, swipe up/down to select the extrusion speed, unit in mm/s, click the blank area around to exit after selection

System Service Page​

Loading...
Loading...
  • Click the corresponding service in Figure 1 above to display the popup in Figure 2, allowing you to start, restart, or stop the corresponding system service
  • Future OTA updates will support all services that Moonraker can operate

Setting Page​

  • To be updated
Loading...