Skip to main content

Halo Page Operation Introduction

Page Structure​

  Print Files Page        Home Page         Extrude Page        System Service        Setting Page       Device Info
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
|             |    |             |    |             |    |             |    |             |    |             |
| Print Files |<-->|     Home    |<-->|   Extrude   |<-->| Sys Service |<-->|   Setting   |<-->|  Dev Info   |
|             |    |             |    |             |    |             |    |             |    |             |
+-------------+    +-------------+    +-------------+    +-------------+    +-------------+    +-------------+
                         ∧
                         |
                         ∨
                   +-------------+
                   |             |
                   | Blocking Det|
                   |             |
                   +-------------+
                  Filament Clog Detection Page
        (This page appears only if clog detection is enabled in settings)

Home Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below.
  1. Click: Enter extruder temperature setting, adjust temperature by dragging the circular bar, click area 1 again to confirm the set temperature.
  2. Click: Enter heated bed temperature setting, adjust temperature by dragging the circular bar, click area 2 again to confirm the set temperature.

Extrude Page​

Loading...
Loading...
  • The operable areas in Figure 1 above correspond to the numbers below.
  1. Click: Increase extruder target temperature by 1.
  2. Long Press: Enter extruder temperature setting, adjust temperature by dragging the circular bar, click again to confirm the set temperature.
  3. Click: Decrease extruder target temperature by 1.
  4. Click: Extrude.
  5. Swipe Up/Down: Select extrusion or retraction length, unit: mm.
  6. Click: Retract.
  7. Long Press: Enter extrusion speed setting shown in Figure 2 above, swipe up/down to select extrusion speed, unit: mm/s, click the surrounding blank area to exit after selection.

System Service Page​

Loading...
Loading...
  • Clicking the corresponding service in Figure 1 above will pop up the dialog shown in Figure 2, allowing you to start, restart, or stop the respective system service.
  • Future OTA updates will support all services operable within Moonraker.

Setting Page​

  • To be updated
Loading...