install

Installation Guide

Installation on Voron Stealthburner

• Installing Halo on Stealthburner requires using the adapter we provide.
• First, download and print the model we provide.
  • Click the download link below.
• Loading...

Antenna Installation

Loading...

Loading...

FPC Installation

• Install the FPC cable as shown in the image above (do not reverse the FPC cable direction; the blue side should face up).

Loading...

Loading...

Mounting Bracket Installation

Loading...

Loading...

Loading...

Loading...

Thread the FPC Through the Cable Hole as Shown Above

Loading...

Loading...

As Shown in Figure 1 Above, First Align the Bottom Clip, Then Press the Top into Place. Figure 2 Shows the Installed Appearance.

Loading...

Loading...

Install the Adapter Board and Connect the Cable

• The cable exit position can be arranged according to your preference; it does not necessarily have to be flush against the back of the fan.

Loading...

Important Notes

• Wire Color Explanation:
  • Black is the negative GND.
  • Red is the positive VCC, which accepts a voltage of DC 12-24V.
  • White is GPIO47, which can be used for filament runout detection.
  • Yellow is GPIO48, which can be used for print completion shutdown.

Installation on Filament Runout Sensor

• To be updated.