Skip to main content

How to Adjust the Module Trigger Value

Use the serial port tool, the following command is available: Send "SET_PIN PIN=_probe_ready VALUE=1" to the Klipper console, observe the trigger indicator light, adjust the threshold from small to large until the indicator light does not light up. Input the following command:

SET_PIN PIN=_probe_ready VALUE=1

Enter the following command in the serial port tool to adjust the trigger value:

set trigger value

  • Commands used in the serial port tool:

  • Send v via the serial port to output adc values in real time. a: before filtering; b: after filtering.

  • Send uv via the serial port to turn off output.

  • Send rt via the serial port to view the current threshold.