Connect to BambuLab

Important Note

• AirClick must be connected to the same network as the target printer
• Only LAN mode connection to BambuLab printer is supported

1. Enable LAN Only Mode on the BambuLab printer

   • Turn on the BambuLab printer screen
   • Settings -> LAN Only Mode -> Enable
   

2. Click on System Settings on the left

   

3. Select BambuLab for Printer Type

4. Click the Refresh Device List button

   

5. Select the printer

   
   • If your printer does not appear after refreshing, you can choose to enter it manually. Enter the printer's IP address and serial number

6. Enter the access code

   • The access code is the LAN mode access code of the printer, which can be viewed in the printer's settings as per step 1
   

7. After configuring as shown above, click Submit at the bottom right to save the configuration

8. A prompt will appear at the top of the web page if the connection is successful

   

9. If the connection fails

   • Check if the IP address is correct
   • Check if the printer and AirClick are connected to the same network
   • Check if the printer has LAN mode enabled
   • Check if the access code is entered incorrectly