Connect to BambuLab

Important Notes

• AirClick must be connected to the same network as the target printer
• Only LAN mode connection is supported for BambuLab printers

1. Enable LAN Only Mode on your BambuLab printer

   • Open the BambuLab printer screen
   • Settings -> LAN Only Mode -> Enable
   Loading...

2. Click on the left system settings

   Loading...

3. Select BambuLab as the Printer Type

4. Click the refresh device list button

   Loading...

5. Select the printer

   Loading...
   • If your printer does not appear after refreshing, you can choose to manually enter the printer's IP address and serial number.

6. Enter the access code

   • The access code is the LAN mode access code of the printer. It can be viewed in the printer's settings following step 1.
   Loading...

7. After configuring as shown above, click Submit at the bottom right to save the configuration

8. A prompt will appear at the top of the webpage upon successful connection

   Loading...

9. If connection fails

   • Check if the IP address is correct
   • Check if the printer and AirClick are connected to the same network
   • Check if the printer has LAN mode enabled
   • Check if the access code is entered incorrectly