Skip to main content

Connecting to the Network via SSH

  • Ensure the system is powered on and connected to the upper computer via SSH using a serial port. It is recommended to use MobaXterm_Personal.
  • Make sure the upper computer is equipped with an M2WE or 2.4G_WiFi module. For Lite2 and MiniPad, no module installation is required.
  • Note that the 2.4G_WiFi module, Lite2, and MiniPad can only use 2.4G_WiFi and cannot use 5G WiFi.
  • Please note that the network must not use dual-band fusion; otherwise, it will not connect properly.
  • Ensure the antenna is already installed!!!
  1. Enter the nmtui command in the SSH software and press Enter. The interface shown below will appear.
Loading...
  1. Press Enter, then select Activate a connection, and press Enter again.
Loading...
  1. Select the network you want to connect to, press Enter, enter the WiFi password, then select OK to save and connect.
Loading...
  1. After connecting to the WIFI, press the Esc key on the keyboard several times to exit the current interface, then enter ip a and press Enter.

  • The IP address 192.168.2.136 shown in the figure is the IP address of the upper computer.

    Loading...
Loading...